关于Graphic window 在预处理时没能自动打开

老师，您好！

我在用DPARSFA 进行预处理的时候，通常会自动显示两个窗口，一个是进度条，一个是 spm Graphic窗口(即头动校正以后，会出现6个参数校正曲线图的窗口)。但最近进行预处理，Graphic窗口没有出现，看不到6个参数校正后的曲线图，也没在RalignParameter folder内找到那个 spm 曲线图文档。但有 rp*.txt文件。 

我单独使用SPM进行头动校正后，那个曲线图文档也没有出现。

不知道这是什么原因造成，能给些建议吗？ 下面是运行DPARSFA 后（从slice-timing开始）的一些提示信息：

Warning: File: DPARSFA_run.m Line: 658 Column: 60
The temporary variable SliceOrder will be cleared at the beginning of each iteration of the parfor loop.
 Any value assigned to it before the loop will be lost.  If SliceOrder is used before it is assigned in
 the parfor loop, a runtime error will occur.
 See Parallel for Loops in MATLAB, "Temporary Variables".
> In DPARSFA>pushbuttonRun_Callback at 1601
  In gui_mainfcn at 96
  In DPARSFA at 33
Warning: File: DPARSFA_run.m Line: 930 Column: 83
The temporary variable RefFile will be cleared at the beginning of each iteration of the parfor loop.
 Any value assigned to it before the loop will be lost.  If RefFile is used before it is assigned in
 the parfor loop, a runtime error will occur.
 See Parallel for Loops in MATLAB, "Temporary Variables".
> In DPARSFA>pushbuttonRun_Callback at 1601
  In gui_mainfcn at 96
  In DPARSFA at 33
Slice Timing Setup:C01 OK
Warning: Run spm_jobman('initcfg'); beforehand
> In spm_jobman at 107
  In DPARSFA_run>(parfor body) at 685
  In parallel_function at 484
  In DPARSFA_run at 581
  In DPARSFA>pushbuttonRun_Callback at 1601
  In gui_mainfcn at 96
  In DPARSFA at 33

很谢谢！
------------------------------------------------------------------------
Running job #1
------------------------------------------------------------------------
Running 'Slice Timing'